Electronics, DIY, Makers, Hackers and Internet of Things (IoT)
1 year ago in Home Automation
20 hours ago in Home Automation
@ricorico94 you’re correct. When the gateway is in server mode, multiple controllers can connect to the gateway if MY_GATEWAY_MAX_CLIENTS is defined to something larger than the default value of 1. However, things can become very confused if multiple controllers respond...
1 week ago in Home Automation
Hi I have a gateway mysensors on my RPI3 with radio RFM69HW. Is any chance to build gateway on RPI3 but also with chip ATSHA204A ? And how build it...
1 month ago in Home Automation
Perfect!!! Thanks for the update!
2 months ago in Home Automation
Hi I just finished configuring a site map having the sample node (S_DOOR) code above as the only thing and I noticed that it only updates once (only at every restart) to the Paper UI Control, The Basic UI, and...
3 months ago in Home Automation
Thanks @fredswed, updated.
Ah I have just built a test bed with this setup however it appears the circuit diagram in the Fritizing is actually not 100% correct. The red wire from the protoboard is connected to the GND of the Pro Mini...
Technically speaking yes but I don't see the point in reinventing the wheel
I'm getting low readings. The voltage at the sensor was OK. So it had to be the calculation. In my opinion the conversion of the 1023 values into a voltage is missing which can then be calculated further. uint16_t uv...
4 months ago in Home Automation
And how to turn on ATC mode?